DMP Electronics XT30 - Disarming Procedures; Area System Disarming; Disarming During an Alarm Event

Digital Monitoring Products XT30/XT50 Installation Guide
14
INSTALLATION
Model 400 USB Flash Module
1. Remove the yellow and green wires from keypad bus terminals 8 and 9.
2. Place a jumper across the RESET header.
3. Place a jumper across the LOAD header.
4. Connect the USB ash drive to the Model 400 and connect the assembly to the panel’s PROG header.
The LED on the Model 400 will ash and then display steady green.
5. Remove the jumper from the RESET header, press and release the load button on the Model 400 to
initiate the rmware update. The LED on model 400 will ash slowly. If the LED displays fast ashes it
means the rmware update was unsuccessful.
6. The update will take approximately 4.5 minutes and when complete the LED on the Model 400 will
display steady green.
7. Replace the jumper across RESET then remove the USB ash drive and Model 400 assembly.
8. Remove the jumper from the LOAD header.
9. Remove the jumper from the RESET header.
10. Reconnect the yellow and green wires to terminals 8 and 9.
Cellular Connections
17.1 Cellular
The CELL MODULE header is provided to connect a
263C CDMA Cellular Communicator or 263H HSPA+
Cellular Communicator. The cellular antenna connection
protrudes through the top of the enclosure.
Note: DO NOT MISALIGN THE CELL MODULE 12 PIN
CONNECTOR ONTO CELL MODULE HEADER. If needed,
the PCB can be removed from the enclosure to allow
placement of the cell module.
J6
Included 3ft cable
Outputs
J11
1
2
3
4
J20
Wireless
Antenna
connection
J24 Celllular
header
J16
Reset
J18
Load
TX RX
Wireless LEDs
EXP
Link LED
Figure 10: 763 to XT30/XT50 Series
Figure 9: Cellular and 1100 Series Wireless
Antenna Connections
Outputs
J11
1
2
3
4
J16
Reset
J20
1100 Series
Wireless Antenna
connection
Connect
antenna to
right side
only
Brass
Washer
J18
Load
1100 Series
Antenna
(XT50)
J1
Ethernet
TX RX
Wireless LEDs
Programming
J8
XMIT
RCV
263C or 263H
Cellular
Communicator
Wi-Fi Connection
18.1 Wi-Fi
The 763 Wi-Fi Module allows you to add Wi-Fi alarm
signal communication to XT30/XT50 panels. The 763
connects to the 7 pin EXP header on compatible panels
using the included cable and operates at 12VDC from the
panel power supply.
The 763 Wi-Fi Module is compatible with all DMP XT30/
XT50 Series control panels with Level L hardware and
Version 124 or higher rmware.