User Menu XT30/XT50 User Guide 31
5. ADD DEL CHG displays. Select DEL.
6. FAVORITE NUMBER: - is displayed. Enter a Favorite number
between 1 and 20 and press CMD.
7. The Favorite number and name displays. Press CMD and the
Favorite Name and ADD EDIT REMOVE displays.
8. Select REMOVE and the rst Z-Wave device stored in the
Favorite displays.
Remaining devices can be viewed by
pressing the CMD key.
9. Press any select key or area to remove the device from the
Favorite. REMOVE DEVICE FROM FAV? NO YES displays. When
YES is selected, the device is removed from the Favorite.
Transfer Controller (XFER)
This option allows the transfer of all existing Z-Wave devices that
are currently programmed in another manufacturer’s Z-Wave
portable controller to your system.
This operation will overwrite all Z-Wave devices that are
programmed in your system. This option typically occurs at
the time your DMP Z-Wave controller is installed.
Initiate the transfer at the other manufacturer’s Z-Wave portable
controller after starting the transfer on the DMP keypad. Z-Wave
devices are NOT overwritten until the transfer has been initiated at
the other manufacturer’s Z-Wave portable controller. The transfer
should not be stopped once the process has been initiated from the
other manufacturer’s Z-Wave portable controller.
Transfer Operation:
1. Access the User Menu.
2. Press CMD until ZWAVE SETUP? displays.
3. Press any select key or area. The keypad displays
ADD LIST REMOVE.
4. Press CMD again to display FAV XFER OPT. Select XFER. The
keypad displays XFER WILL DELETE EXISTING DEVICES then
displays XFER CNTRL SURE? YES NO.
5. Select YES to to allow receipt of Z-Wave devices to your
system. The keypad displays TRANSFERRING Z-WAVE
DEVICES. Pressing the Back Arrow key cancels the transfer.
Select NO to exit the XFER menu and return to ZWAVE
SETUP?. All programming will still be intact on the DMP
Z-Wave controller and will cancel the transfer.
6. Initiate the transfer at the other manufacturer’s Z-Wave
portable controller. All Z-Wave devices are added to the
system with a default name (device type and number). A
16-character name may be assigned to the Z-Wave devices
after the transfer is complete. When the transfer is
complete the screen will display ZWAVE SETUP?.
To Next Page
Loading...
Need help?
General
