What to do if communication and timing tests may not be made on Doble Measuring Instruments?
If communication and timing tests cannot be performed on your Doble Measuring Instruments, it might be due to using a standard network cable without the correct adapter. To resolve this, use a network cable equipped with a crossover adapter, or use a plain crossover cable.
General| Brand | doble |
|---|---|
| Model | TDR900 |
| Category | Measuring Instruments |
| Language | English |
Explains the meaning of various symbols used in the manual for special interest information.
Outlines the purpose and scope of the user guide for the Doble TDR900.
Discusses the application of the TDR900 test set for performing breaker timing tests.
Introduces the TDR900 instrument and its key components.
Details the various connectors and ports on the TDR900 front panel.
Lists and describes the essential cables, safety grounds, and connection options for the TDR900.
Covers software requirements and various test cable options including OCB, EHV, and Motion.
Describes the Motion, Analog, and Event cable options for connecting external sensors.
Emphasizes safety precautions, general rules, and the importance of proper grounding for apparatus and instruments.
Covers personnel safety measures, including pre-test meetings and communication protocols.
Explains the fundamental roles, ideal characteristics, and operational aspects of circuit breakers.
Details breaker features like tanks and energy sources, and lists common problems that can occur.
Lists common problems with breakers and explains why performing breaker tests is essential.
Focuses on the process and significance of timing the main contacts of a circuit breaker.
Provides guidelines for setting up and preparing the TDR900 instrument and the breaker for testing.
Details the sequence of actions for performing tests, including connecting leads and running tests.
Covers the installation, setup, and initial launch procedures for the T-Doble software.
Explains the management of library plans, breaker plans, and test results within the software.
Describes the software's structure using tabs, sub-tabs, and chart controls for data visualization.
Explains the functions of key buttons and provides an overview of the main navigation tabs.
Details the Breaker and Test Plan tabs for entering breaker data and configuring test parameters.
Covers the Test Results tab, detailing analysis of signals, contacts, motion, and other data.
Explains signal overlay for comparison and guides on connecting to the TDR900 instrument.
Details the procedure for properly closing down the T-Doble software application.
Specifies minimum PC requirements and guides on installing the T-Doble software.
Details procedures for verifying the communication link between the PC and the TDR900 instrument.
Informs about field repair limitations and provides a list of available parts for the TDR900.
To Next Page
