(4) Install mounting bolt and tighten to 28 N·m
(21 ft. lbs.) torque.
(5) Connect electrical connector to sensor.
CAMSHAFT POSITION SENSOR
The camshaft position sensor is located in the dis-
tributor on all 3.9L V-6 and 5.2/5.9L V-8 engines (Fig.
29).
REMOVAL
Distributor removal is not necessary to remove
camshaft position sensor.
(1) Remove air cleaner assembly.
(2) Disconnect negative cable from battery.
(3) Remove distributor cap from distributor (two
screws).
(4) Disconnect camshaft position sensor wiring
harness from main engine wiring harness.
(5) Remove distributor rotor from distributor shaft.
(6) Lift the camshaft position sensor assembly
from the distributor housing (Fig. 29).
INSTALLATION
(1) Install camshaft position sensor to distributor.
Align sensor into notch on distributor housing.
(2) Connect wiring harness.
(3) Install rotor.
(4) Install distributor cap. Tighten mounting
screws.
(5) Install air cleaner assembly.
CAMSHAFT POSITION SENSOR—4.7L ENGINE
The Camshaft Position Sensor (CMP) on the 4.7L
V–8 engine is bolted to the front/top of the right cyl-
inder head (Fig. 30).
Fig. 28 CKP Sensor Location/Removal/Installation—
4.7L V–8 Engine
1 – CRANKSHAFT POSITION SENSOR
2 – MOUNTING BOLT
Fig. 29 Camshaft Position Sensor
1 – SYNC SIGNAL GENERATOR
2 – CAMSHAFT POSITION SENSOR
3 – PULSE RING
4 – DISTRIBUTOR ASSEMBLY
Fig. 30 CMP Location—4.7L Engine
1 – RIGHT CYLINDER HEAD
2 – CAMSHAFT POSITION SENSOR
3 – MOUNTING BOLT
4 – ELEC. CONNECTOR
DN IGNITION SYSTEM 8D - 15
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
