INSTALLATION
(1) Apply an appropriate adhesive/sealant to the
waterdam edges before installing it.
(2) Position the waterdam on the door inner panel
and press it inward at the areas with the adhesive to
attach it to the inner panel.
(3) Ensure that the retainer step pockets are posi-
tion correctly in the door inner panel.
(4) Install the door trim panel.
FRONT DOOR
REMOVAL
(1) Release door latch and open door.
(2) Using a suitable marker, mark the outline of
the door hinges on the door end to aid installation.
(3) Remove protective boot from door wire harness
connector.
(4) Disengage door wire harness connector.
(5) Support door on a suitable lifting device.
Fig. 25 Trim Panel Screw
1 – INNER DOOR PANEL
2 – INSIDE DOOR HANDLE BRACKET
3 – TRIM PANEL
4 – INSIDE DOOR HANDLE
Fig. 26 Trim Panel Retainer
1 – TRIM PANEL
2 – RETAINER STEP
3 – INNER DOOR PANEL
Fig. 27 Speaker And Power Mirror Connector
1 – POWER MIRROR CONNECTOR
2 – TRIM PANEL
3 – SPEAKER CONNECTOR
Fig. 28 Power Door Lock/Window Connector
1 – POWER MIRROR SWITCH
2 – TWEETER
3 – POWER WINDOW SWITCH
4 – WIRE HARNESS CONNECTOR
23 - 32 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
