INSTALLATION
(1) Position seat in vehicle.
(2) Install bolts attaching 3rd row seat to floor pan
(Fig. 97) in the following sequence:
(a) Right front bolt
(b) Left front bolt
(c) Left rear bolt
(d) Right rear bolt
(3) Tighten bolts to 27 N·m (20 ft. lbs.) torque.
(4) Move and latch 3rd row seat cushion to seating
position.
(5) Move and latch 2nd row seat to seating posi-
tion.
FLOOR CONSOLE
REMOVAL
(1) Using a small flat blade, remove forward and
rearward cup holder inserts.
(2) Remove screws attaching floor console to floor
pan (Fig. 98).
(3) Disconnect wire harness for rear HEVAC
blower, if equipped.
(4) Lift console upward and disengage from
HEVAC duct, if equipped.
(5) Separate console from vehicle.
INSTALLATION
(1) Position console in vehicle.
(2) Engage HEVAC duct to console, if equipped.
(3) Connect wire harness for rear HEVAC blower,
if equipped.
Fig. 98 Floor Console
1 – CUP HOLDER INSERT
2 – CUP HOLDER INSERT
3 – FLOOR CONSOLE
4 – HEVAC DUCT
5 – FLOOR PAN
6 – SHIFT BEZEL
Fig. 97 3rd Row Seat
1 – BENCH SEAT
2 – FLOOR PAN
23 - 62 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
