(4) Engage power mirror wire connector from door
harness, if equipped.
(5) Install mirror flag seal.
(6) Install door trim panel.
FRONT DOOR TRIM PANEL
REMOVAL
(1) Release door latch and open door.
(2) Roll window down.
(3) Remove window crank (Fig. 23), if equipped.
(4) Remove screws attaching trim panel to door
(Fig. 24) and (Fig. 25).
CAUTION: Do not forcibly pull trim panel from
door, damage to trim panel may occur.
(5) Simultaneously lift upward and outward to
release retainer steps from inner door panel (Fig. 26).
(6) Disengage inside handle linkage rod from
inside handle.
(7) Disconnect speaker harness wire connector
(Fig. 27).
(8) Disengage power mirror wire connector, if
equipped (driver’s side only) (Fig. 27).
(9) Disengage clips attaching power window/lock
switch panel to door trim panel. Disengage wire con-
nector from switch panel, if equipped (Fig. 28).
(10) Separate door trim panel from vehicle.
INSTALLATION
(1) Position trim panel at door.
(2) Engage wire connector for window/lock switch
panel, if equipped.
(3) Engage power mirror wire connector, if
equipped.
(4) Connect speaker harness wire connector.
(5) Engage inside handle linkage rod to inside
handle.
(6) Align trim panel retainer steps with inner door
panel and slide trim panel into place.
(7) Install screws attaching trim panel to door.
(8) Install window crank, if equipped.
FRONT DOOR WATERDAM
REMOVAL
(1) Remove the trim panel from the door.
(2) Carefully separate the waterdam from the door
inner panel at the areas with adhesive (Fig. 29).
Remove the waterdam from the door inner panel.
Fig. 22 Side View Mirror Connectors
1 – ELECTRIC FOLD AWAY SIDEVIEW MIRROR
2 – DOOR
3 – ELECTRIC SIDEVIEW MIRROR
Fig. 23 Window Crank—Typical
1 – WINDOW CRANK REMOVAL TOOL
2 – WINDOW CRANK
Fig. 24 Door Trim Panel
1 – TRIM PANEL
DN BODY 23 - 31
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
