(4) Disengage glass from regulator lift channel.
(5) Position glass up into door frame (rest glass on
a block of wood on door reinforcement).
(6) Lower waterdam.
(7) Disconnect regulator wire harness, if equipped.
(8) Remove screws attaching window regulator to
door inner panel (Fig. 55) and (Fig. 56).
(9) Remove window regulator from door.
INSTALLATION
(1) Position window regulator in door.
(2) Loosely install screws attaching window regu-
lator to door inner panel.
(3) Install glass onto regulator lift channel. Secure
fasteners.
(4) Connect regulator wire harness, if equipped.
(5) Cycle the window glass to the full up position.
(6) Tighten bolts attaching the regulator to the
inner door panel.
(7) Install waterdam.
(8) Install door trim panel.
(9) Install upper door trim extension panel.
REAR DOOR GLASS RUN WEATHERSTRIP
REMOVAL
(1) Remove trim panel.
(2) Remove inner beltline weatherstrip.
(3) Remove outer beltline weatherstrip.
(4) Pull weatherstrip from door frame and divider
bar channel (Fig. 57).
Fig. 54 Door Opening Weatherstrip
1 – UPPER BODY SEAL
2 – PRIMARY DOOR SEAL
Fig. 55 Rear Door Window Regulator—Manual
1 – REAR DOOR
2 – MANUAL REGULATOR
Fig. 56 Rear Door Window Regulator—Power
1 – REAR DOOR POWER REGULATOR
2 – NUT
Fig. 57 Glass Run Weatherstrip
1 – REAR DOOR
2 – GLASS RUN WEATHERSTRIP
DN BODY 23 - 43
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
