INSTALLATION
(1) Position liner in wheelhouse.
(2) Install plastic rivets attaching wheelhouse liner
to wheelhouse.
(3) Install wheel opening molding.
(4) Install the front wheel.
(5) Remove the support and lower the vehicle.
LEFT FRONT FENDER
REMOVAL
(1) Remove battery.
(2) Raise and support the vehicle.
(3) Remove left front wheel.
(4) Remove wheel opening molding.
(5) Remove wheelhouse liner.
(6) Remove left headlamp module.
(7) Remove PDC (power distribution center).
(8) Remove battery tray and battery support
bracket (Fig. 13).
(9) Remove HCU (hydraulic control unit) if
equipped. Refer to Group 5, Brakes for service proce-
dures.
(10) Disengage clips attaching hood release cable
to inner fender.
(11) Disengage clips attaching wire harness to
inner fender and wheelhouse.
(12) Remove bolt attaching fender to lower rocker
panel.
(13) Remove bolts attaching fender to lower radia-
tor closure panel (Fig. 15).
(14) Remove bolts attaching fender to hood hinge
support bracket.
(15) Remove bolts attaching fender to upper cowl
(Fig. 14).
(16) Remove bolts attaching fender to upper radia-
tor closure panel.
(17) Separate fender and wheelhouse from vehicle.
INSTALLATION
(1) Position fender and wheelhouse from vehicle.
(2) Install bolts attaching fender to upper radiator
closure panel.
(3) Install bolts attaching fender to upper cowl.
(4) Install bolts attaching fender to hood hinge
support bracket.
(5) Install bolts attaching fender to lower radiator
closure panel.
(6) Install bolt attaching fender to lower rocker
panel.
(7) Position the hood release cable to inner fender
and engage clips.
(8) Position the wire harnesses on the inner fender
and wheelhouse and engage clips.
(9) Install HCU if equipped. Refer to Group 5,
Brakes for service procedures.
(10) Install battery support bracket and battery
tray.
(11) Install PDC (power distribution center).
(12) Install left headlamp module.
(13) Install battery.
(14) Install wheelhouse liner.
(15) Install wheel opening molding.
(16) Install left front wheel.
(17) Remove the support and lower the vehicle.
RIGHT FRONT FENDER
REMOVAL
(1) Disconnect battery negative cable.
(2) Raise and support the vehicle.
(3) Remove right front wheel.
(4) Remove wheel opening molding.
(5) Remove wheelhouse liner.
(6) Remove right headlamp module.
(7) Remove air cleaner element housing.
Fig. 13 Battery Tray and Support Bracket
1 – FRONT FENDER
2 – BATTERY TRAY SUPPORT BRACKET
3 – BATTERY TRAY
23 - 26 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
