INSTALLATION
(1) Install the upper latch cover onto the upper
latch inertia arm. Ensure the check strap loops
under the stud on the side of the lower stanchion/
post.
(2) Install the lower latch cover onto the inertia
latch upper arm working it around the latch bracket.
(3) Align the lower latch cover, the upper latch
cover, and the latch bracket to the screw hole on the
arm.
(4) Secure the cover with the screw and tighten to
4.15N·m (37 in. lbs.).
(5) Cycle the armrest through a full range of travel
and check for freedom of movement. Adjust the latch
covers as necessary.
CENTER SEAT CUSHION/COVER
REMOVAL
(1) Remove the bucket seats.
(2) Separate the center seat from the bucket seats.
(3) Remove the armrest/seat back.
(4) Disengage the J-straps from the cushion frame
(Fig. 6).
(5) Separate the cushion/cover from the frame.
INSTALLATION
(1) Position the cushion/cover on the frame.
(2) Engage the J-straps from the cushion frame.
(3) Install the armrest/seat back.
(4) Attach the center seat to the bucket seats.
(5) Install the bucket seats.
2ND ROW SEAT BACK
REMOVAL
(1) Tumble seat forward.
(2) Remove tumble release outboard handle.
(3) Remove inboard & outboard side shields (Fig.
7).
(4) Disengage J-straps to access inboard and out-
board bolts attaching seat back to hinge (Fig. 8).
(5) Remove bolts attaching hinge to seat back.
(6) Separate seat back from vehicle.
Fig. 6 Center Seat Cushion/Cover
1 – J-STRAPS
2 – CENTER SEAT CUSHION COVER
Fig. 7 2nd Row Seat Side Shield
1 – OUT BOARD SIDE SHIELD
2 – SEAT BACK
3 – SEAT CUSHION
Fig. 8 2nd Row Seat Back J-Straps
1 – SEAT BACK
2 – HINGE BRACKET
3 – BOLTS
4 – J-STRAP
DN BODY 23 - 13
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
