(2) Align spring clips and press inward to secure.
D-PILLAR TRIM
REMOVAL
(1) Remove liftgate opening upper trim.
(2) Remove screw attaching D-pillar trim to upper
liftgate opening.
(3) Remove 3rd row seat, if equipped.
(4) Remove nut attaching 3rd row seat belt anchor
to quarter panel, if equipped.
(5) Remove bolt attaching 3rd row seat belt turn-
ing loop to D-pillar, if equipped (Fig. 85).
(6) Grasp upper edge of D-pillar trim and carefully
pull outward to disengage upper spring clips.
(7) Lift D-pillar trim upward to release it from the
quarter panel trim.
(8) Route 3rd row seat belt through access slot, if
equipped.
(9) Separate D-pillar trim from vehicle.
INSTALLATION
(1) Route 3rd row seat belt through access slot, if
equipped.
(2) Position D-pillar trim on D-pillar.
Fig. 83 C-Pillar Trim
1 – ADJUSTER
2 – C-PILLAR TRIM
3 – TURNING LOOP
4 – QUARTER PANEL TRIM
5 – ANCHOR BOLT
6 – BELT ANCHOR
7 – ANTI-RATTLE CUP
8 – RETRACTOR
9 – C-PILLAR
Fig. 84 Liftgate Opening Upper Trim
1 – SPRING CLIP
2 – LIFTGATE OPENING UPPER TRIM
23 - 54 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
