FRONT DOOR INNER BELT WEATHERSTRIP
REMOVAL
(1) Remove screws attaching trim panel to door.
(2) Lift trim panel up and over inner belt seal.
(3) Peel seal from door (Fig. 36).
INSTALLATION
(1) Slide seal into position on door.
(2) Position trim panel over inner belt seal and
install screws.
FRONT DOOR OUTER BELT WEATHERSTRIP
REMOVAL
(1) Lower glass.
(2) Lift rearward corner of weatherstrip and slide
weatherstrip rearward (Fig. 36).
INSTALLATION
(1) Lightly lubricate weatherstrip with silicone and
slide weatherstrip behind mirror.
(2) Push weatherstrip down to seat onto door.
FRONT DOOR GLASS
REMOVAL
(1) Remove door trim panel.
(2) Remove water dam as necessary to gain access
to glass regulator arm.
(3) Remove inner door belt weatherstrip.
(4) Remove outer door belt weatherstrip.
(5) Lower glass to full down position and align
glass regulator arm with access holes in inner door
panel.
(6) Remove front glass run channel.
(7) Remove screws attaching glass channel to reg-
ulator arm (Fig. 37).
(8) Separate glass from regulator arm.
(9) Lift glass upward and out of opening at top of
door.
Fig. 35 Front Door Latch Striker
1 – TAPPING PLATE
2 – SHIM
3 – STRIKER
4 – B-PILLAR
Fig. 36 Front Door Weatherstrip/Seals
1 – B-PILLAR SECONDARY SEAL
2 – GLASS RUN WEATHERSTRIP
3 – INNER BELT WEATHERSTRIP
4 – SECONDARY SEAL
5 – OUTER BELT WEATHERSTRIP
Fig. 37 Door Glass
1 – DOOR GLASS
23 - 36 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
