INSTALLATION
(1) Position seat back in vehicle.
(2) Install bolts attaching hinge to seat back.
Tighten bolts to 27 N·m (19 ft. lbs.) torque.
(3) Engage inboard and outboard J-straps.
(4) Install inboard & outboard side shields (Fig. 7).
(5) Install tumble release outboard handle.
(6) Return seat to seating position.
2ND ROW SEAT BACK COVER
NOTE: CLOTH TRIM IS BONDED TO SEAT FOAM
REMOVAL
(1) Tumble seat forward.
(2) Disengage J-strap at seat back base.
(3) Disengage inboard and outboard J-straps on
seat back.
(4) Return seat to seating position.
NOTE: When removing the head restraint sleeves
and guides, the retaining tabs on the sleeves and
guides will be damaged. Check the availability of
replacement parts before servicing.
(5) Remove head restraint, head restraint sleeves,
and head restraint guides. Discard sleeves and
guides.
(6) Roll cover upward and remove from seat back.
INSTALLATION
(1) Position cover on seat back.
(2) Roll cover downward over seat back.
(3) Install new head restraint sleeves and guides.
Install head restraint.
(4) Tumble seat forward.
(5) Engage inboard and outboard J-straps on seat
back.
(6) Engage J-strap at seat back base.
(7) Return seat to seating position.
2ND ROW SEAT CUSHION COVER
REMOVAL
(1) Remove tumble release handle.
(2) Remove latch side shield.
(3) Remove seat from frame. Refer to 2nd Row
Seat Cushion for removal procedures.
(4) Disengage J-straps attaching cover to seat
cushion frame.
(5) Separate cushion/cover from seat frame.
INSTALLATION
(1) Position cushion/cover on seat frame.
(2) Engage J-straps attaching cover to seat cushion
frame.
(3) Install seat to frame. Refer to 2nd Row Seat
Cushion for installation procedures.
(4) Install latch side shield.
(5) Install tumble release handle.
2ND ROW SEAT CUSHION
REMOVAL
(1) Remove seat back.
(2) Position seat cushion in forward tumble posi-
tion.
(3) Using a breaker bar or equivalent, rotate the
outboard spring loaded pivot pin to release seat cush-
ion from frame (Fig. 9).
(4) Remove the pivot pin and spring.
(5) Separate seat cushion from frame.
INSTALLATION
(1) Position seat cushion on frame.
(2) Align the pivot pin and spring with seat cush-
ion and frame.
(3) Using a breaker bar or equivalent, rotate the
outboard spring loaded pivot pin to engage spring
and secure seat cushion to frame.
(4) Install seat back.
2ND ROW SEAT LATCHES
The 2nd row seat latches are serviced as a set.
REMOVAL
(1) Remove seat back.
(2) Disengage J-straps on seat cushion frame (Fig.
10).
Fig. 9 Pivot Pin And Spring
1 – SEAT CUSHION
2 – SPRING
3 – FRAME
4 – BREAKER BAR
23 - 14 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
