Dodge 2000 DURANGO - 3 Rd Row Seat; Installation; 2 Nd Row Seat

(II) Passenger’s front inboard
(III) Driver’s front inboard
(IV) Passenger’s front outboard
Tighten bolts attaching front seat track to floor
pan to 28 N·m (20 ft. lbs.) torque.
(4) Install front screws attaching trim cover to seat
track.
(5) Move seat to full forward position.
(6) Install bolts attaching rear inboard seat track
to floor pan. Tighten to 40 N·m (30 ft. lbs.) torque.
(7) Install bolts attaching rear outboard seat track
to floor pan. Tighten to 28 N·m (20 ft. lbs.) torque.
(8) Install rear screws attaching trim cover to seat
track.
(9) If equipped, engage power seat switch connec-
tor and install side shield.
2ND ROW SEAT
The 2nd row seat is removed as a complete assem-
bly.
REMOVAL
(1) Move seat to the forward tumble position.
(2) Remove outboard bolts attaching seat to the
floor pan (Fig. 95).
(3) Remove inboard bolts attaching seat belt
buckle anchors and seat to floor pan (Fig. 96).
(4) Remove seat from the vehicle.
INSTALLATION
(1) Position seat in the vehicle.
(2) Install inboard bolts attaching seat belt buckle
anchors and seat to floor pan (Fig. 96). Tighten bolts
to 95 N·m (70 ft. lbs.) torque.
(3) Install outboard bolts attaching seat to the
floor pan (Fig. 95). Tighten bolts to 27 N·m (20 ft.
lbs.) torque.
(4) Move and latch seat in the seating position.
3RD ROW SEAT
REMOVAL
(1) Move 2nd row seat to forward tumble position.
(2) Lift 3rd row seat cushion upward and forward
to floor cargo position.
(3) Remove bolts attaching 3rd row seat to floor
pan (Fig. 97).
(4) Remove seat from vehicle.
Fig. 95 2nd Row Seat
1 – REAR SEAT
2 – FLOOR PAN
Fig. 96 2nd Row Seat Belt Anchors
1 – BUCKLE ANCHOR
2 – FLOOR PAN
3 – REAR SEAT (2ND SEAT)
DN BODY 23 - 61
REMOVAL AND INSTALLATION (Continued)