(6) Tighten the mount bracket to crossmember
retaining bolts (4x4 automatic transmission only) to
28 N·m (250 in. lbs.).
STRUCTURAL COVER
REMOVAL
(1) Raise vehicle on hoist.
(2) Remove the left hand exhaust pipe from
exhaust manifold. Refer to Group 11, Exhaust Sys-
tem.
(3) Loosen the right hand exhaust manifold-to-ex-
haust pipe retaining bolts.
(4) Remove the eight bolts retaining structural
cover (Fig. 39).
(5) Pivot the exhaust pipe downward and remove
the structural cover.
INSTALLATION
CAUTION: The structural cover must be installed
as described in the following steps. Failure to do so
will cause severe damage to the cover.
(1) Position the structural cover in the vehicle.
(2) Install all four bolts retaining the cover-to-en-
gine. DO NOT tighten the bolts at this time.
(3) Install the four cover-to-transmission bolts. Do
NOT tighten at this time.
CAUTION: The structural cover must be held tightly
against both the engine and the transmission bell
housing during tightening sequence. Failure to do
so may cause damage to the cover.
(4) Starting with the two rear cover-to-engine
bolts, tighten bolts (1) (Fig. 39) to 54 N·m (40 ft. lbs.),
then tighten bolts (2) (Fig. 39) and (3) to 54 N·m ( 40
ft. lbs.) in the sequence shown.
(5) Install the exhaust pipe on left hand exhaust
manifold.
(6) Tighten exhaust manifold-to-exhaust pipe
retaining bolts to 20–26 N·m (15–20 ft. lbs.).
Fig. 37 Engine Rear Mount—4X2 and 4X4 Manual
Transmission
1 – THROUGH BOLT
2 – BOLT
3 – INSULATOR SUPPORT
4 – NUT
5 – NUT AND WASHER
6 – INSULATOR BRACKET TO TRANSMISSION
Fig. 38 Engine Rear Mount—4X4 Automatic
Transmission
1 – TRANSMISSION
2 – ENGINE REAR MOUNT
3 – BOLT
Fig. 39 Structural Cover
9 - 30 4.7L ENGINE DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
