INSTALLATION
(1) Clean the contact area with Mopar Super
Kleen or equivalent.
(2) Remove the carrier for the seal
(3) Align the seal on the door and press into place.
REAR DOOR SECONDARY SEAL
REMOVAL
(1) Separate the secondary seal from the inner
door panel
INSTALLATION
(1) Thoroughly clean the area of old adhesive. Use
Mopar Super Kleen or equivalent.
(2) Position the secondary seal on the inner door
panel.
ROOF RAIL WEATHERSTRIP AND RETAINER
REMOVAL
(1) Release door latch and open door.
(2) The rearward corner of the weatherstip is
adhesively attached to the body. Peel back the corner
of the weatherstrip to release it from the body.
(3) Pull weatherstrip from retainer (Fig. 61).
(4) Remove screws attaching retainer to roof rail
(Fig. 62).
(5) Separate retainer from vehicle.
INSTALLATION
NOTE: The screws attaching the retainer to the roof
are coated with wax to prevent water leakage. If the
retainer has been removed from the roof, replace
the screws.
(1) Ensure the area where tape secures the weath-
erstrip is clean. Use Mopar Super Clean or equiva-
lent.
(2) Position retainer on vehicle.
(3) Install screws attaching retainer to roof rail.
(4) Starting at the forward end of retainer, push
weatherstrip on until seated.
(5) Peel the backing from the rearward end of the
weatherstrip and press to secure.
BODY SIDE MOLDINGS
REMOVAL
(1) Apply a length of masking tape on the body,
parallel to the top edge of the molding to use as a
guide, if necessary.
Fig. 60 Rear Door Secondary Seal
1 – REAR DOOR SILL SECONDARY SEAL
Fig. 61 Roof Rail Weatherstrip
1 – UPPER BODY SIDE SEAL
Fig. 62 Roof Rail Retainer
1 – RETAINER
DN BODY 23 - 45
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
