(3) Slid D-pillar trim downward to engage it with
the quarter panel trim.
(4) Align D-pillar trim upper spring clips and
press inward to engage.
(5) Install screw attaching D-pillar trim to upper
liftgate opening.
(6) Install liftgate opening upper trim.
(7) Install bolt attaching 3rd row seat belt turning
loop to D-pillar, if equipped (Fig. 85). Tighten bolt to
39 N·m (29 ft. lbs.) torque.
(8) Install nut attaching 3rd row seat belt anchor
to quarter panel, if equipped. Tighten nut to 39 N·m
(29 ft. lbs.) torque.
(9) Install 3rd row seat, if equipped.
QUARTER PANEL TRIM
REMOVAL
(1) Tumble 2nd row seats to cargo position.
(2) Remove 3rd row seat, if equipped.
(3) Remove C-pillar trim (Fig. 83).
(4) Remove D-pillar trim.
(5) Remove liftgate opening scuff pad.
(6) Remove screws attaching quarter panel trim to
C-pillar and D-pillar.
(7) Route 2nd row seat belt through access slot in
quarter panel trim.
(8) Grasp quarter panel trim and pull outward to
disengage spring clips.
(9) Separate quarter panel trim from vehicle.
INSTALLATION
(1) Position quarter panel trim in vehicle.
(2) Route 2nd row seat belt through access slot in
quarter panel trim.
(3) Align quarter panel trim spring clips and press
inward to engage.
(4) Install screws attaching quarter panel trim to
C-pillar and D-pillar.
(5) Install D-pillar trim.
(6) Install C-pillar trim.
(7) Install liftgate opening scuff pad.
(8) Install 3rd row seat, if equipped.
(9) Return 2nd row seats to seating position.
Fig. 85 D-Pillar Trim
1 – D-PILLAR
2 – RETRACTOR
3 – ANTI-RATTLE CUP
4 – BUCKLE
5 – ANCHOR BOLT
6 – STUD
7 – BELT ANCHOR
8 – TURNING LOOP
9 – D-PILLAR TRIM
DN BODY 23 - 55
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
