INSTALLATION
(1) Position weatherstrip in door frame and divider
bar channel.
(2) Install outer beltline weatherstrip.
(3) Install inner beltline weatherstrip.
(4) Install trim panel.
REAR DOOR GLASS RUN CHANNELS
REMOVAL
(1) Remove trim panel.
(2) Remove waterdam.
(3) Ensure glass is in full up position and sup-
ported. Remove bolts attaching the run channels to
door inner panel (Fig. 58).
(4) Remove speaker, if necessary.
(5) Separate run channels from door.
INSTALLATION
(1) Position run channels in door.
(2) Install bolts attaching the run channels to door
inner panel (Fig. 58).
(3) Install speaker, if necessary.
(4) Install waterdam.
(5) Install trim panel.
REAR DOOR GLASS
REMOVAL
(1) Remove trim panel.
(2) Remove waterdam.
(3) Remove inner beltline weatherstrip
(4) Remove outer beltline weatherstrip.
(5) Remove glass run weatherstrip.
(6) Remove bolts attaching door glass to regulator
(Fig. 58).
(7) Separate door glass from door.
(8) Remove bolt attaching bottom of reward run
channel to door inner panel.
(9) Remove nuts attaching stationary glass to door.
(10) Separate rearward run channel/stationary
glass from door.
(11) Pull to separate stationary glass from run
channel.
INSTALLATION
(1) Ensure glass and run channel are clean.
(2) Apply butyl adhesive to glass and insert in
glass run channel.
(3) Install nuts attaching stationary glass to door.
Tighten nuts to 3 N·m (30 in. lbs.) torque.
(4) Install bolt attaching bottom of reward run
channel to door inner panel.
(5) Position door glass in door.
(6) Install bolts attaching door glass to regulator
(Fig. 58). Tighten bolts to 11 N·m (105 in. lbs.)
torque.
(7) Install glass run weatherstrip.
(8) Install outer beltline weatherstrip.
(9) Install inner beltline weatherstrip
(10) Install waterdam.
(11) Install trim panel.
C—PILLAR SEAL
REMOVAL
The seal is attached to the door with adhesive
tape.
(1) Peel the seal from the door (Fig. 59).
Fig. 58 Rear Door Glass Run Channels
1 – RUN CHANNEL WITH STATIONARY GLASS
2 – REAR DOOR
3 – REGULATOR
4 – RUN CHANNEL
5 – DOOR GLASS
Fig. 59 B-Pillar Seal
1 – C-PILLAR SEAL
23 - 44 BODY DN
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
