Dodge 2000 DURANGO - Page 785

DISASSEMBLY AND ASSEMBLY
PUMP PULLEY
DISASSEMBLY
(1) Remove pump assembly.
(2) Remove pulley from pump with Puller C-4333
(Fig. 6).
ASSEMBLY
(1) Replace pulley if bent, cracked, or loose.
(2) Install pulley on pump with Installer C-4063-B
(Fig. 7) flush with the end of the shaft. Ensure the
tool and pulley remain aligned with the pump shaft.
(3) Install pump assembly.
(4) With Serpentine Belts; Run engine until warm
(5 min.) and note any belt chirp. If chirp exists, move
pulley outward approximately 0.5 mm (0.020 in.). If
noise increases, press on 1.0 mm (0.040 in.). Be
careful that pulley does not contact mounting
bolts.
SPECIFICATIONS
TORQUE CHART
DESCRIPTION TORQUE
5.2L/5.9L Power Steering Pump
Pump Bracket Bolts ........ 41N·m(30ft.lbs.)
Pump Mounting Bolts ...... 41N·m(30ft.lbs.)
Flow Control Valve ........ 75N·m(55ft.lbs.)
Pressure Line ............. 35N·m(25ft.lbs.)
4.7L Power Steering Pump
Pump Mounting Bolts ...... 28N·m(21ft.lbs.)
Flow Control Valve ........ 81N·m(60ft.lbs.)
Pressure Line ............. 35N·m(25ft.lbs.)
SPECIAL TOOLS
POWER STEERING PUMP
Fig. 6 Pulley Removal
1 – POWER STEERING PUMP DRIVE PULLEY
2 – SPECIAL TOOL C-4333
Fig. 7 Pulley Installation
1 – POWER STEERING PUMP DRIVE PULLEY
2 – SPECIAL TOOL C-4063–B
Analyzer Set, Power Steering Flow/Pressure 6815
Adapters, Power Steering Flow/Pressure Tester
6893
DN STEERING 19 - 9