Dodge 2000 DURANGO - Page 815

REAR DOOR STATIONARY GLASS
REMOVAL
(1) Remove trim panel.
(2) Remove waterdam.
(3) Remove inner beltline weatherstrip
(4) Remove outer beltline weatherstrip.
(5) Remove door glass from door.
(6) Remove bolt attaching bottom of rearward run
channel to door inner panel.
(7) Remove nuts attaching stationary glass to door
(Fig. 6).
(8) Separate rearward run channel/stationary
glass from door.
(9) Pull to separate stationary glass from run
channel.
INSTALLATION
(1) Ensure glass and run channel are clean.
(2) Apply butyl adhesive to glass and insert in
glass run channel.
(3) Install nuts attaching stationary glass to door.
Tighten nuts to 3 N·m (30 in. lbs.) torque (Fig. 6).
(4) Install bolt attaching bottom of rearward run
channel to door inner panel.
(5) Position door glass in door.
(6) Install door glass to regulator.
(7) Install outer beltline weatherstrip.
(8) Install inner beltline weatherstrip
(9) Install waterdam.
(10) Install trim panel.
Fig. 3 Center Windshield and Mark at Support
Spacers
1 – WINDSHIELD
2 – INDEX MARKS
3 – SUPPORT SPACERS
Fig. 4 Work Surface Set up and Molding Installation
1 – WINDSHIELD AND MOULDINGS
2 – URETHANE BEAD AROUND GLASS 7mm (.3 in.) FROM
EDGE
3 – BLOCKS
Fig. 5 Applicator Tip
1 – APPLICATOR TIP
Fig. 6 Rear Door Stationary Glass
1 – RUN CHANNEL WITH STATIONARY GLASS
2 – REAR DOOR
3 – REGULATOR
4 – RUN CHANNEL
5 – DOOR GLASS
DN BODY 23 - 7
REMOVAL AND INSTALLATION (Continued)