(4) Remove screws attaching trim panel to door
(Fig. 43).
CAUTION: Do not forcibly pull trim panel from
door, damage to trim panel may occur.
(5) Simultaneously lift upward and outward to
release retainer steps from inner door panel (Fig. 44).
(6) Disengage inside handle linkage rod from
inside handle.
(7) Disconnect power widow/lock harness connec-
tor, if equipped (Fig. 45).
(8) Separate door trim panel from vehicle.
(9) If necessary, pull upper trim extension outward
to disengage from rear door.
INSTALLATION
(1) If removed, install upper trim extension on
rear door.
(2) Position trim panel at door.
(3) Engage harness connector for power window/
lock, if equipped.
(4) Engage inside handle linkage rod to inside
handle.
(5) Align trim panel retainer steps with inner door
panel and slide trim panel into place.
(6) Install screws attaching trim panel to door.
Fig. 42 Window Crank—Typical
1 – WINDOW CRANK REMOVAL TOOL
2 – WINDOW CRANK
Fig. 43 Rear Door Trim Panel
1 – UPPER TRIM EXTENSION
2 – REAR DOOR
3 – PLASTIC SNAP-IN NUT
4 – TRIM PANEL
Fig. 44 Trim Panel Retainer
1 – TRIM PANEL
2 – RETAINER STEP
3 – INNER DOOR PANEL
Fig. 45 Power Window/Lock Connector
1 – TRIM PANEL
2 – INSIDE HANDLE LATCH ROD
3 – POWER WINDOW/LOCK CONNECTOR
DN BODY 23 - 39
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
