MAINTENANCE AND FAULT FINDING
5-18 L025317 Issue 1 March 2011
3224 Invalid Setup The system setup is
inconsistent (some
settings don't fit to
others).
Check message setup, create a
new message.
3225 Batch finished A batch (e.g. coding
from a file) has been
finished printing.
Load another coding file or set
the line number within the
coding file to a valid line
within the file and then re-
enable marking.
3226 Referenced glyph
not found in font
The character that is
referenced by the
message of a text
object does not exist
in the font that is
used.
Change marking font.
3227 Marking disabled
by counter
A counter ending
action has disabled
printing.
Marking has been disabled as
this counter has now reached
its end value. Attention: even
counters that are not used
within the message but
globally active can disable
marking!
3228 Font not installed The font referenced
by the text object is
not installed in the
system.
Install the font, use a different
font.
3229 Font too large The font file is too
large to fit into the
printer controller's
memory.
Use another font or minimize
the amount of different fonts
used within the message.
3230 Corrupt font file The font file could
not be loaded as it has
been identified as
corrupt.
Replace the font file, use a
different font.
3231 PN
transformation -
invalid
parameters!
The parameters for
the PN
transformation are
not valid.
Check the PN setup, try
automatic setup.
Status Message Cause Suggested Action
To Next Page
Loading...
Need help?
General