¥
Apply engine oil to the entire face of the
tappets and slide them into the tappet
holes on the cylinder block.
¥
Wet the cam bush inside diameter and
camshaft with oil, and carefully assem-
ble them while turning the camshaft.
¥
Check to see that the camshaft rotates
smoothly.
9.3.5. Crankshaft
¥
Install the main bearing machined with
two holes in the cylinder block so that the
key is aligned with the key groove, then
apply oil to the bearing surface.
¥
Heat the crankshaft gear for at least 10
minutes to 120
ûC
, then apply sealant
(Loctite # 641) to the inside wall of the
heated crankshaft gear evenly before
inserting it to the end of crankshaft.
- 92 -
To Next Page
Loading...
