After all setup changes are finished, return to the RUN mode. Reinstall
the cover by reversing the removal procedure. Make sure all the screws
are reinstalled in their original positions and the gasket is properly
installed. Tighten the screws as required.
Stepping through the menu functions:
Once the setup mode has been entered, it is possible to step through the
setup menu by pressing and releasing UNITS or S2. A different display
prompt is generated for each item in the setup menu.
Changing a Parameter:
Once the desired menu item has been found, it may be necessary to
change the parameter associated with that item. Press and release
ZERO to step through the individual parameters. When the bottom of a
parameter list is reached, the scale will restart the list at the top.
Reviewing Setup Parameters:
Setup parameters for the 7000XL may be reviewed without opening the
scale. Remove power and press the hidden button (located ½" above the
PRINT button). Apply power. Hold the button until the scale begins to
scroll through the setup parameters. The button may be released anytime
after the review has begun.
To access the parameters on the 7000, follow the same procedures, but
press the ZERO button.
Legal for Trade Restrictions:
The Legal for Trade mode disables certain setup options and menus. The
following pages list and describe the setup parameters and menus. Any
Item marked by an asterisk will not be available in the Legal for Trade
operating mode.
15
To Next Page
Loading...
