Doran 7000 - Start up Units Selection Menu; Push-Button Function Setup Menu; Remote Push-Button Configuration Menu

Start Up Units Selection Menu
UnIts Start Up Units Select Mode
Configures selection of start up units.
Press ZERO to scroll through the units activated in the
CSL mode. The selected units will be displayed on
the units indicators to the right of the display.
Note: If an invalid start up unit is selected for a given capacity, the
scale will automatically change the unit setting to a valid unit
when exiting the setup menu.
Note: Start up units may be set without using the setup menu.
While in the weighing mode, select the desired start up
units. Switch the scale into the setup/calibration mode by
toggling S1. Switch S1 back to the RUN mode. The scale
will now power up in the desired units.
Push-button Function Setup Menu
P.b.
Push Buttons
Configures the active push button functions.
CP UNITS and PRINT enabled.
P PRINT enabled only.
C UNITS enabled only.
non UNITS and PRINT disabled.
Remote Push-button Configuration Menu
r.P.b. Remote Push Button
Configures the remote switch to perform one of
the three front panel functions.
off The remote switch is disabled.
P The remote switch functions as a PRINT button.
C The remote switch functions as a UNITS button.
0 The remote switch functions as a ZERO button.
22