23
Figure 6A: Sample Reference Label
PRINT PARAMETERS
Print speed
The print speed (material feed) can be adjusted according to the ribbon and material
combination being used in order to optimize the contrast depth and the density of the
print image.
inch/s Setting range: see table; Unit interval: 1 inch/s Default setting: 8 inch/s
Table 1A: Print Speed Ranges for Available Printers
Feed speed
The feed speed can be increased between print periods hereby reducing the total print
time, particularly with long labels with a minimum printed surface. Available feed
speeds are the same as print speed, please refer to Table 1A above for a complete
listing.
Setting: The value for the feed speed should not be set too high for print applications
with long calculating units (e. g. consecutive numbering). This can help to avoid
alternating between abrupt braking to 0 and acceleration to print speed, which can
affect print quality and also cause product to skew during transport. When altering the
Print Speed Range (in/sec)
To Next Page
Loading...