26
EAN sep. lines
Parameter for controlling of EAN or UPC barcodes if they are printed without read
line.
With readl. only (Default) The separation bars at the beginning, end and in the
middle of the barcode are only long, if the barcode is printed with a read line.
Always long The separation bars at the beginning, end and in the middle of the
barcode are always long, regardless if the barcode is printed with or without read
line. The position of the barcode is the same as with the read line option switched
on.
Rotated Barcodes
Improves the readability of rotated (90° and 270°) bar codes.
Normal Normal printing without a special processing of rotated bar codes.
Optimized (Default setting) The line and gap widths of rotated bar codes are
modified in order to improve their readability.
X-print adjust
The zero point of the mask is moved in relation to the edge of the label on the X- axis,
i.e. lengthways to the material. If the setting is changed, while the print job is stopped,
the printer recalculates the format using the changed values. Caution with graphics. If
the graphics are shifted beyond the label border as a consequence of changing the
parameter X-print adjust, the part of the graphics which "juts out" will not print.
x inch/s Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm Default: 0.0 mm
• Maximum offset away from the edge of the label: +5.0 mm
• No offset: 0.0mm
• Maximum offset towards the edge of the label: -5.0 mm
Y–print adjust
The zero point of the mask is moved in relation to the gap position on the y-axis, i.e.
in the feed direction. If the setting is changed, while the print job is stopped, the
printer recalculates the format using the changed values. Caution with graphics, If the
graphics are shifted beyond the label border as a consequence of changing the
parameter Y-print adjust, the part of the graphics which “juts out” will not print.
x inch/s Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm Default: 0.0 mm
To Next Page
Loading...