34
Reflex Material end detection by means of a reflex sensor.
Transparent Material end detection by means of a transmission sensor.
Disabled No material end detection.
Periph. device
After installation, options must be selected under "Peripheral device" in order to be
assured of the corresponding sensor queries and printer reactions.
CAUTION! - Selecting an incorrect option can lead to malfunctions or
damage!
None No peripheral device is installed.
Cutter Sets the printer firmware to the cutter option. Selection permits access to
the cut parameters.
Rewinder Sets the printer firmware to the rewinder option. Selection permits
access to the rewinder setting parameters.
Tear-off edge Sets the printer firmware to the tear-off edge option. The punch is
fed forward to the tear-off edge.
Dispenser Setting for 64-xx dispenser version.
Singlestartquant
Determines the number of product to be printed after a single start signal has been
received.
xx Setting range: 1 to 10; Unit interval: 1
External signal
The parameter determines, if and how an incoming signal at the - optional - single
start connector will be interpreted.
Disabled Signal interpretation disabled.
Singlestart The signal triggers the printing of a single label. This setting may be
used e.g. for printing single labels by means of a foot switch or on-demand tray.
Stacker full The signal triggers the display of a status report and stops the printer.
This setting may be used when using a stacker (= stacker full signal).
Start mode
Ways of interpreting the start signal:
Level Labels of a certain print job are being printed as long as the signal level is
“high". When using a foot switch, labels are printed as long as the switch is
depressed.
To Next Page
Loading...