35
Edge The rising / falling signal edge triggers the printing of exactly one label
(Default setting).
See parameter Signal edge on page 23.
Start source
Choose a signal source for the start signal:
Foot switch Optional foot switch is used to generate the start signal.
Light barrier (Default setting) Photoelectric switch at the dispensing edge which
detects the taking off of the printed product.
USI USI interface (only with installed USI board)
Signal edge
This parameter determines either the falling or the rising edge of an incoming signal
as trigger.
Falling edge The falling signal edge triggers a certain printer reaction.
Rising edge The rising signal edge triggers a certain printer reaction.
Signal / buzzer
On Tone signal activated
Off Tone signal deactivated
Special Function
Delete job
Press the Online-key to cancel the active print job.
Delete spooler
Press the Online-key to delete all print jobs contained in the spooler.
Factory settings
All parameters are preset ex works to values specific to each device type. These
factory settings can be restored at any time. All parameters are then overwritten by
the factory settings. The currently valid settings can be checked using PRINT INFO >
printer status.
CAUTION! - All data present in the spooler, including data belonging to an
To Next Page
Loading...