To Next Page
E
Evan WangAug 1, 2025
How to restart DoraniX ThermaPrint 64?
- CCarrie ShafferAug 1, 2025
To restart the DoraniX Printer, press and hold the Cut, Online, and Feed buttons simultaneously.
How to restart DoraniX ThermaPrint 64?
To restart the DoraniX Printer, press and hold the Cut, Online, and Feed buttons simultaneously.
How to change material length on DoraniX ThermaPrint 64?
To change the material length on the DoraniX Printer, first press the Online button until 'Offline' appears. Then, press Prog * Esc to enter the menu. Select 'Print_Parameters' using the Cut button, then navigate to 'Materiallength' (bottom line) using the Cut button again. Adjust the length to 180.2 mm using the Cut and/or Feed buttons, and confirm with the Online button.
How to perform head dot test DoraniX ThermaPrint 64 Printer?
To perform a Head Dot Test on the DoraniX Printer, press and hold the Cut and Feed buttons simultaneously.
How to advance product and ribbon on DoraniX Printer?
To advance the product and ribbon on the DoraniX Printer, press and hold the Feed and Online buttons simultaneously.
How to manually calibrate product length DoraniX ThermaPrint 64 Printer?
To manually calibrate the product length on the DoraniX Printer, press and hold the Feed and Prog Esc buttons simultaneously.
What to do if I need to run product transport backwards on DoraniX Printer?
To run the product transport backwards on the DoraniX Printer, press and hold the Cut and Online buttons simultaneously.
Step-by-step guide to installing the printer, drivers, and optional accessories for initial use.
Step-by-step guide for safely cleaning the printer's sensitive print head.
Detailed explanation of print job settings like speed, material, and positioning.
Configuration options for printer functions, warnings, and system behavior.
General| Print Resolution | 203 DPI |
|---|---|
| Print Technology | Thermal |
| Maximum Print Width | 64 mm |
| Interface | USB |
| Paper Type | Thermal paper |