Thermaprint 64 User Manual
5
Printer
1. Remove printer from box and place all shipping materials in a location where they
can be used later should the printer need to be shipped back for repair.
2. Follow the setup instructions in the following pages for any options your printer
may have.
3. Plug the printer in using the supplied power cord and turn it on.
4. Install the ribbon as shown in Figure 1 on page 6 and by the video provided on
www.doranix.com.
5. Place a stack of product in the feeder. Place them in such a way so that they are
shingled and the bottom piece of product will always be the first to enter the
machine.
6. Feed a few samples through and make sure that the printer feeds as desired
(should feed consistently with a gap between the samples).
7. Start Printing!
Printer Interface
1. Download the driver to be used with the desired interface from
www.doranix.com.
2. If printing with USB or Serial simply plug in the interface cord, select the correct
driver and print.
3. If printing over the network with an Ethernet cable, select the correct driver and
set the desired IP on the printer by following these steps:
1. Enter the menu by putting the printer offline and pressing Prog-Esc
2. Press Cut to get to Interface Para
3. Go down to Network Param.
4. Go to IP address and make sure it is set correctly. If not, change it to the
correct value and restart the printer.
To Next Page
Loading...