33
• xx%: Up to xx% temperature reduction with a hot print head.
Voltage offset
The voltage offset increases the head voltage and therefore the head temperature
which e.g. was set by Easy Plug command (HV).
xx% Setting range: 0 to 20%; Unit interval: 1% Default setting: 0%
Miss. label tol.
The maximum search length for gaps which cannot be found can be varied. In cases
of difficult gap detection (i.e. minimum variation in the light transparency, gap to
label), shortening the search path is to be recommended. Label loss resulting from
gaps not being detected can be reduced in this way. Printing does not take place
during the search process.
xx Setting range: 0 to 10; Unit interval: 1
• Example: 0 (Zero label length) A gap must be found after a printed label
otherwise an error message is given. This setting is for immediately detecting every
missing label.
Gap detect mode
After one of the following events, the printer must always search for a gap between
products:
• After switching the printer on
• After changing the label material
Manual The operator has to initialize the material always manually by pressing
the feed key several times.
Autom. Forward (Default for printers) The material initialization is always done
automatically, if necessary. There is no backward movement of the material
during the initialization.
Mat. end detect.
The material end detection can be deactivated for processing labels with gaps longer
than 15 mm, or if using material with a high fluctuation in light transparency (ST05 =
material end is displayed even though material is present).
CAUTION! - Reel material should not be processed when the material end
detection is deactivated! With this setting, printing continues on the print roller after
the end of the material, leading to shorter cleaning intervals or damage.
To Next Page
Loading...