24
print speed, the feed speed is set equal to the print speed. If a different feed speed is
required, this must be reset either manually or using a job modifier within the labeling
software.
Material type
Definition of the materials used. A distinction is made between reel material and
gapped material (hole gaps, self-adhesive material with register gaps). The detected
gap position corresponds to the start of the label.
Endless: If material is to be used without gaps. Not recommended for the
Thermaprint 64.
Punched: If material is to be used with gaps (default setting)
Material length
The material length (label length) is the distance between the gaps, measured from the
front edge (beginning) of a label to the front edge of the next label.
xxx mm: Setting range: 5 mm to "max. length entry"; Unit interval: 0.1 mm
Default setting: 100 mm
Maximum length entry is dependent on the print head width and memory
configuration.
Material width
Zero position is the inside edge of the print head.
xxx mm: Setting range: "min. width" to "max. width"; Unit interval: 0.1 mm
Default setting: 100 mm
• Min. width: dependent on the printer type
• Max. width: dependent on print head width and memory configuration.
Print direction
Rotates the print according to the feed orientation of the product.
Foot first: (Default) Prints from the bottom to the top of the print image.
Head first: Prints from the top to the bottom of the print image.
To Next Page
Loading...