32
Single job mode
In single job mode (also stop mode) the printer stops after every job and waits until
the operator restarts the print process.
Deactivated Single job mode is switched off (default setting).
Activated Single job mode is switched on. The printer always displays "Start next
job", before starting a new print job. This requests the user to acknowledge by
pressing the Online button.
Head resistance
For optimum print quality, the individual print head resistance of the print head
installed in the device must be set once with this parameter. When replacing the print
head, the resistance value of the print head (to be read off from the print head) must
be entered again.
CAUTION! - Entering a false value can damage the print head!
«Read off the correct value from the print head and set it accordingly.
The value set here remains when the factory settings are carried out.
xxxx Ohm Setting range: 1000 to 1500 Ohm; Unit interval: 1 Ohm
Setting the print head resistance:
Setting:
1. From the print head, read off the resistance value to be set and make a note
of it (1000 to 1500).
2. In off-line mode press the Prog. button, display: PRINT INFO.
3. Press the Cut button until SYSTEM PARAMETER is displayed.
4. Press the Online button, display:
5. Press the Cut button until the following is displayed:
6. Press the Online button, set value is displayed.
7. Set the previously noted resistance value of the print head using the Feed and Cut
buttons.
8. Press the Online button to confirm the set value.
9. Press the Prog. button to return to the display OFFLINE 0 JOBS.
Temp. reduction
Allows the power supply to be reduced in the event of an increase in the print head
temperature, thereby ensuring an even print image.
xx% Setting range: 0 to 50%; Unit interval: 10%
The following setting alternatives are available:
• 0%: No temperature reduction (default).
To Next Page
Loading...