Thermaprint 64 User Manual
9
for most printing is 6ips. If you feel as if this speed is not what it should be, please
contact DoraniX technical support at 303-271-0986.
Label Length: It is very important that the length of the product is set correctly in
the software. If you believe this may be wrong check with the person who created
the image. An incorrect material length could result in every other piece of
product being printed on or even only the first being printed on.
X-adjust print location
There are several ways to adjust the x-location of the image being printed. They are as
follows:
Move the image in the software - This is an a quick and simple fix to the x-
location of the image being off, however it is not always feasible if there are a
high number of image files being used.
Move the printhead – By loosening the thumbscrews on the printhead and sliding
it back and forth over the product the x-location of the image moves with it. Be
sure to tighten the thumbscrews before attempting to print.
X-print adjust setting – In the menu under Print Parameters is the setting X-print
adjust. The settings specs are as follows: x inch/s Setting range: -5.0 to +5.0 mm;
Unit interval: 0.1mm Default: 0.0 mm
• Maximum offset away from the edge of the label: +5.0 mm
• No offset: 0.0mm
• Maximum offset towards the edge of the label: -5.0 mm
To Next Page
Loading...