31
Ribbon autoecon.
The ribbon feed can be interrupted during print periods with the ribbon automatic
economy parameter. This saves ribbon, particularly with long labels with a minimum
print area. The automatic function should only be activated with unprinted areas from
approx. 10 mm in length. A selection can be made between thermal transfer printing
and thermal direct printing. It is necessary to select the type of printing in order to be
able to switch over the ribbon end detection.
Thermal printing Thermal direct printing (Ribbon-end-LS switched off)
Activated Thermal transfer printing with ribbon automatic economy mode on.
Deactivated Thermal transfer printing with ribbon automatic economy mode off.
Ribbon economy limit
The ribbon economy limit determines the length of the printing free area on the label
from that on the ribbon economy automatic should be activated.
x.xx mm Setting range: xx up to 100,0 mm; Unit interval: 0,1 mm (the initial
value depends on the feed speed) Default-value: 5.0 mm
Turn-on mode
Operating mode of the printer after it has been switched on.
Online Printer starts in on-line mode.
Offline Printer starts in off-line mode.
Standalone Printer starts in standalone mode.
Interface delay
After switching from online to offline mode, the printer interface is deactivated. This
parameter offers a settable delay time before deactivating the interface.
xxxx ms Setting range: 0-1000; Unit interval: 100; Default setting: 0
Error reprint
If an error occurs while a label is printed, the last printed label will normally be
reprinted. In case of label layouts containing variable data like e.g. count fields, is
recommended.
Enabled Reprint in error cases (default setting)
Disabled No reprint in error cases.
To Next Page
Loading...