14
E7900 Series
C. Privacy Function: Lockout of Keycards
Turn the thumbturn to the horizontal position for privacy.
(On autodeadbolt models press and hold the auxiliary latch
(D5) to extend the deadbolt, then turn the thumbturn for
privacy. On storeroom locks, skip this test.)
Use the Grand Master Keycard (not applicable on E7900).
The red LED flashes once. Then turn the outside lever
downward. The latch does not retract.
Important: For multihousing 79T, verify that you hear the
motor while turning the thumbturn. If you don't, the lock
is not programmed as 79T and must be re-programmed as
79T.
For multihousing 79M, verify that you don't hear the motor
while activating the thumbturn. If you hear the motor the
lock is programmed as 79T and must be re-programmed as
79M.
D. Emergency Keycard Access:
Deadbolt Deactivation:
A. Deadbolt Deactivation by Thumbturn
While standing inside the room, close the door, and then
turn the thumbturn to extend the deadbolt. (If the lock has
an autodeadbolt mortise go to step B below).
Turn the thumbturn to retract the deadbolt. Repeat.
B. Deadbolt Deactivation by Lever
While standing inside the room, close the door and turn the
thumbturn to the horizontal position to extend the deadbolt
(or to select privacy on autodeadbolt models). Open the
door by turning the lever. The deadbolt and the latch bolt
retract simultaneously and fully. Take note of any excess
friction which might necessitate filing the strike (deadbolt
area only). Repeat
4 Lock Testing
for mechanical override, see Step 8 Page 37
Deadbolt Override
Use the Emergency keycard with the reader. The red
LED flashes for 4 seconds. Turn the outside lever downward
while the red LED is flashing. The deadbolt and latch bolt
retract simultaneously and fully.
While standing outside the room close the door and
ensure that it is properly latched. Open the door using
the Grand Master keycard using the same procedure.
E . Inside and Outside Lever Detection for
Toggle Mode only.
Before fastening the inside trim assembly to the
outside housing assembly, check that the lever switch
(W2) is well connected to the wire harness (W1) (see
p.5). Check that the thumbturn (T) is in the vertical
position as shown in step 5 page 11.
Verify the lock is in passage mode while the thumbturn is
in vertical position. For that, activate the outside lever
handle and verify the latch bolt retracts. Rotate the thumb-
turn to horizontal position and then activate outside
lever handle. Latch bolt must not retract as the lock
should be in locked mode. Rotate the inside lever
handle and verify the latch bolt retract and the
thumbturn returns to vertical position. Rotate outside
lever handle verify the latch bolt retracts as the lock
should be in passage mode.
If it does not operate as described above, that means
the lock is not programmed as a 79T or is defective.
Present the emergency card to the reader. (The LED
will flash for 4 seconds). Rotate the lever as soon as the
LED starts flashing - The LED will stop flashing. If it
does not, there is a problem with the lever detection.
KD10114-E-1122
To Next Page
Loading...
Need help?
General
