5 Programming and Software Setup - Aurora
Joining a Lock to a Gateway (Aurora) continued...
11.
Repeat steps 8 to 10 for each door/lock you
wish to join to your Gateway.
If you have locks you wish to join to a different
Gateway, return to the Status screen and place
this Gateway in “Join On” mode, then join each
lock as described in the previous steps. Newer
versions of Aurora only allow you to place one
Gateway in “Join On” at any given time, so you
might have to place any other Gateways in your
site to “Join Off” first if they have not already
timed out.
Once you have joined all of your E-Plex doors/
locks, return to the Status screen and place
each of your Gateways back to “Join Off” if
they have not already timed out.
12.
13.
27
E7900 Series
KD10114-E-1122
To Next Page