EasyManua.ls Logo

Dormakaba ED900 - Table of Contents

Dormakaba ED900
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Table of Contents
Table of contents
General information
. General information
Safety information
Technical data
. ED technical data
. Operating specifications; ED operators
Operational mode overview
. ED manual and automatic modes
. Low energy product
User interface
. Overview
.  button keypad and display
. Mode switch and Exit Only switch panels
. Operator status LEDs
System accessories 
. System accessory electrical connections 
. System accessories 
. Terminal board interfaces 
ED door signage 
. Low energy operator,
ANSI/BHMA A. 
. Door signage, low energy single swing
door, ANSI/BHMA A. 
. Door signage, low energy pair swing doors,
ANSI/BHMA A. 
AAADM Safety information label 
. Safety information label, low energy power
operated doors 
 Parameters 
. ED – viewing and changing parameters 
. Configuration parameters 
. Driving parameters 
Table of contents
System setup for single door installation 
. Set ED operator spring tension 
. Set braking circuit plug position 
. Power on 
. Set installation type parameter AS 
. Set door width parameter Tb 
. Set reveal depth parameter rd 
. Set door type parameter dL 
. Perform learning cycle 
. Set power fail closing speed 
 Initial setup – pair doors 
. Separately setup active and inactive
doors 
. Set operator parameters for pair door
operation 
. Connect sync cable between operators 
 Set track bumper stop 
. Set track bumper stop position 
 Install push arm door stop 
. Install push arm door stop
(optional assembly) 
 Check door signage 
. Check door signage 
 Install cover, end caps and spindle caps 
. Install fine cover and end caps 
. Install spindle caps, fine cover 
 Upgrade cards 
. Upgrade cards 
. Container module 
. Installing upgrade cards 
 ANSI/BHMA standards 
. Low energy power operated doors
(ANSI/BHMA A.) 
Appendix A - Driving parameters 
A. Driving parameters – detail 
Appendix B - Troubleshooting 
B. Information and error codes 
B. Red LED status codes 
B. Troubleshooting chart, "ln" codes 
B. Troubleshooting chart, "E" codes 

Table of Contents

Other manuals for Dormakaba ED900

Related product manuals