Dormakaba ED900 - Set Door Width Parameter Tb

22
ED900 09-2021DL4617-001
dormakaba ED900 Setup and Troubleshooting Instructions Chapter 10
Table .. ED door widths
and Tb parameter values.
Tb factory setting = .
. Set door width parameter Tb
Step 
Press
Scroll to Tb parameter.
Step 
Press
Displays "" , factory setting.
Step 
Press
"" starts flashing.
Step 
Press
Scroll to 
Step 
Press
Scroll to 
Step 
Press
Saves value.
Display stops flashing.
Step 
Press
Returns to door width parameter.
Step 
Go to Para. ., Set reveal depth rd.
Tb
Door width
Door width measurement
Inches [mm] Tb
 -  / [] - [] 
 -  / [] - [] 
 -  / [] - [] 
 -  / [] - [] *
 -  / [] - [] 
 -  / [] - [] 
.. Set Tb door width parameter value.
.. Set parameter TB value = .
NOTICE
. If door width =  -  /", Set Tb = .
• "" is Tb factory setting.
• For system to recognize Tb = , steps in
Para. .. must be followed.
. Set TB parameter to value other than .
• Follow steps in Para. ..
.. Measure door width.
. Measure door width in inches or mm
Step 
Press
Scroll to Tb parameter.
Step 
Press
Displays "" , factory setting.
Step 
Press
"" starts flashing.
Step 
Press
Scroll to 
(Door width =  -  /" as
example)
Step 
Press
Saves value entered.
Display stops flashing.
Step 
Press
Returns to door width parameter.
Step 
Go to Para. ., Set reveal depth
parameter rd.
.. Set parameter TB to value other than .