Half/Pack
®
Issued April 2018
Body and Tailgate
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Body and Tailgate
45
SERVICE HOIST RAISE/LOWER OPERATION (CONTINUED)
A. Raising the Body
1. Empty body of all refuse.
2. Make sure that body is on firm, level ground with the Parking Brake engaged and holding.
3. CLOSE the manual override valve on the power unit – PUSH the knob IN and turn it CLOCKWISE.
4. Remove the bolts and springs from the chassis mounting brackets.
5. If equipped with quick disconnects, uncouple prior to raising the body.
6. Make sure there is adequate slack in hoses that do not have disconnects. If there is not adequate slack in hoses that
do not have disconnects, remove those hose clamps.
7. Observe and obey the DANGER labels for an elevated chassis.
8. PRESS and HOLD the UP button to RAISE the body.
9. RELEASE the UP button when the body is at the height you want.
10.Release the prop handles and LOWER the body props, then PRESS the DOWN button to lower the body onto the
lugs.
11.NEVER open the override valve when the body is elevated.
12.Perform the maintenance or service procedures.
B. Lowering the Body
1. PRESS the UP button until the body is not resting on the body props.
2. RAISE the body props and store the handles.
3. Press and hold the DOWN button to lower the body.
4. Release the DOWN button when the body is completely down and resting on the chassis.
5. OPEN the manual override valve – PUSH the knob IN and turn it COUNTER-CLOCKWISE.
6. Make sure the manual override valve is open – PUSH the service hoist UP button. The body will not raise.
7. If any hose clamps were removed to create adequate slack during body raise, then re-install those hose clamps.
8. If equipped with quick disconnects, reattach the quick disconnects.
9. Install the bolts and springs to the chassis mounting brackets.
To Next Page
Loading...