Half/Pack
®
Issued April 2018
Maintenance and Adjustment
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Maintenance and Adjustment
61
CUROTTO-CAN OPTIONAL SINGLE POINT LUBRICATION GUIDE
Clean fittings before applying grease and always pump enough grease into joint to remove the old grease. Wipe off excess
grease. Lubricate moveable mechanical parts without fittings every 60 days with non-detergent engine oil.
The Curotto-Can comes standard with a multiple point lubrication system or with an optional single point lubrication system.
For the Single Point Lubrication System:
Both the grease and the fittings MUST be clean
There MUST not be any blocked lines or ports due to its series operation. Never cap or block any of the lubrication
lines as this will the block flow of grease to the entire system. Repair any damaged lines or system components
immediately.
To Next Page
Loading...