Half/Pack
®
Issued April 2018
Maintenance and Adjustment
Copyright 2018, Heil Environmental
Printed in the U.S.A.
Maintenance and Adjustment
67
SERVICE MODE
event of a Cylinder or Packer Sensor failure on route to recover to a safe arms and forks position. Service Mode can also
be used to move the functions while servicing a failed Cylinder Sensor.
Service Mode is to be used ONLY by authorized service personnel. Unauthorized use of Service Mode can result in
extensive damage to the unit.
The arms, forks and packer will move very, very slowly due to the unit being in Service Mode.
1. Place the unit in Service Mode.
a.
and release.
b. The password screen will appear on the display.
c. Enter the service password 4 3 2 1 and press OK.
d. The bottom option should be Service Mode. Select it with the arrows and then press OK making sure that option
changes from OFF to ON.
e. Press ESC to exit.
2. When service is complete, go back to the maintenance screen and turn off Service Mode. See Step 1 above. Service
Mode also resets if power to the unit is cycled.
To Next Page
Loading...