24 Dover Fueling Solutions W2940305 Rev 07 8/2019
4.2 Configuring the Dispenser Software
4.2.1 General
The Select S1 dispenser series utilizes a very sophisticated electronics platform that
offers a variety of controls, error monitoring, and diagnostics. The dispenser software
configuration defines how the dispenser operates, what features are available, display
formats, etc.
The configuration settings are pre-loaded at the factory based upon the model and
options. All that should be necessary is to verify the time and date settings, and if the
pulse output interface option is installed, verify that the pulse ratio is set to the desired
resolution.
Appendix E contains a complete list of the dispenser functions and sub-functions and the
default settings for each dispenser model should any other changes be required.
4.2.2 Making Configuration Changes
The dispenser configuration and diagnostics can be
accessed without opening the dispenser. The interface is
handled through an infrared remote control (IRC). One IRC
is shipped with each order of dispenser(s). See Figure 4-1.
To use the IRC, point it at the dispenser’s liquid crystal
displays from within a distance of one foot and press the
desired keys.
Responses to the IRC commands are shown on the
dispenser displays. For units without price displays,
configuration function and sub-function numbers are shown
in the Status display and their corresponding values are
shown in the Gallons/Liters display. Reference Figure 4-2.
For units with price displays, the information used during the
configuration is typically displayed using all three displays.
The configuration is password protected. To access the
configuration and verify the time and date settings, follow the
step by step instructions on the next page.
NOTE: The nozzle hook on/off lever must be in the “off” position
to access the configuration.
Figure 4-1 Infrared
Remote Control (IRC)
DFS PN: WM002290
To Next Page
Loading...
