Dräger Infinity Series User Manual

Page 7-6 Infinity Gamma Series VF4
Assigning Network Recorders
For monitors connected to the Infinity network, you can choose a
primary and secondary recorder/laser printer within the network.
The monitor sends a recording request first to the primary record-
ing device. If that device is busy or unavailable (i.e. out of paper),
the monitor sends the request to the secondary recording device.
If no recording device is available, the monitor stores the record-
ing (see the section Stored Recordings in this chapter).
STEPS: Assigning Network Recording Devices
1. Press the Menu fixed key.
2. Click on
Monitor Setup.
3. Click on
Recordings.
4. Click on
Primary Recorder, select the desired recorder/
printer and click the knob again.
5. Click on
Secondary Recorder, select a secondary recorder/
printer, if available, and click the knob again.
NOTES:
! R50 Series recorders and laser printers in a wireless network
are identified in the menu by the device label assigned to them
during network configuration. Laser printers in a conventional
network (monitor is docked at a Docking Station) are identified
by the label LP.
! The Infinity network supports only one laser printer.

Dräger Infinity Series Specifications

General

Manufacturer	Dräger
Device Type	Patient Monitor
Weight	5 kg to 10 kg (depending on the model and configuration)
Connectivity	Ethernet, USB, WLAN (optional)
Parameters Monitored	ECG, SpO2, NIBP, Temperature, Respiration
Alarm System	Visual and audible alarms, customizable alarm limits
Device Category	Medical Device
Series	Infinity
Display	Color TFT
Display Size	12.1 inches
Power Supply	AC Power, Internal Battery
Battery Life	Up to 4 hours (depending on configuration)