Dräger Infinity Series User Manual

Page 14-14 Infinity Gamma Series VF4
Autozero Delay
The Scio module is self-zeroing. It automatically initiates zeroing
of its gas sensors against room air about every 2 hours. During
zeroing, the monitor does not update the displayed Scio parame-
ter values on the screen. If zeroing cannot be completed within 25
seconds, the monitor blanks the Scio parameter values and dis-
plays an error message (see the chapter Alarms and Messages).
One minute before the start of zeroing, the monitor sounds an
attention tone (2 beeps) and displays the message Multigas zero
in 1 minute. You can delay zeroing once for a 5-minute period as
follows:
STEPS: Requesting an Autozero Delay
1. In OR mode, click on the O2/N2O/Agent parameter box.
2. Click on
Autozero Delay.
WARNING: Delaying zeroing may compromise the
accuracy of gas values.
NOTE: The menu selection Autozero Delay is only displayed and
available for one minute, just before zeroing starts.

Dräger Infinity Series Specifications

General

Manufacturer	Dräger
Device Type	Patient Monitor
Weight	5 kg to 10 kg (depending on the model and configuration)
Connectivity	Ethernet, USB, WLAN (optional)
Parameters Monitored	ECG, SpO2, NIBP, Temperature, Respiration
Alarm System	Visual and audible alarms, customizable alarm limits
Device Category	Medical Device
Series	Infinity
Display	Color TFT
Display Size	12.1 inches
Power Supply	AC Power, Internal Battery
Battery Life	Up to 4 hours (depending on configuration)