Description | en
X-am
®
2800 / X-am
®
5800 45
3.2 Intended use
Dräger X-am 2800/X-am 5800 is a portable gas detector for continuous
monitoring of the concentration of several gases in the ambient air within the
working area and in explosion-hazard areas.
The gas detector is suitable for both indoor and outdoor applications for which
an IP 68 degree of protection and certified explosion protection (see name plate)
are sufficient. The gas detector is not suitable for use under jets of water.
3.3 Approvals
A copy of the name plate, the declaration of conformity, and the sensor data
relevant for measurement purposes are provided in the enclosed supplementary
documentation (part no. 9300308) or at
www.draeger.com/ifu.
The name plate on the gas detector must not be damaged or concealed. If
the name plate is damaged, it must be replaced by Dräger Service.
FCC:
The radio license information can be found in the information on the device. For
further information see: "Opening device information", page 54.
3.4 GPL (General Public License)
Depending on their configuration, Dräger products which use software use Open
Source software. This is regularly subject to special licensing conditions which
take precedence in their scope. Several Open Source software licensing
conditions may apply in a single Dräger product, which then apply respectively
to the associated software components. Further information on the Open Source
software used in this products is available on the following Internet page:
www.
draeger.com/opensource.
CO H
2 compensation CO+
H
2 added signal ch4+
Feature Shown in display
To Next Page
Loading...
Need help?
General
