Dräger Polaris 600 User Manual

Instructions for use Polaris 600 51
Operation
Functional principle of the LED indicator
The illuminance can be set in 12 steps. These 12
steps are visualized by the 6 LEDs of the LED
indicator, which light up accordingly with half or full
brightness.
– At minimum illuminance, the LED (B) of the
LED indicator is lit at half brightness.
1 When the key (A) is pressed once, the
LED (B) of the LED indicator lights up with full
brightness.
2 When the key (A) is pressed twice, the
next LED (C) of the LED indicator lights up with
half brightness.
3 When the key (A) is pressed again, the LED
(C) of the LED indicator lights up with full
brightness.
– At maximum illuminance, all the LEDs of the
LED indicator are lit with full brightness.
Setting illuminance on the sterilizable
handle E
A wiping motion with one finger across the surface
of the operating section at any location will adjust
the illuminance. Each wiping motion changes the
illuminance by one step.
265122651326558
B
B
A
C
A
4128741285
NOTE
If several fingers touch the operating section of
the sterilizable handle E simultaneously, the
operating signal will not be implemented. Only
one finger at a time must touch the operating
section.
C
A

Dräger Polaris 600 Specifications

General

Brand	Dräger
Model	Polaris 600
Category	Medical Equipment
Language	English