DragonWave Horizon COMPACT - Page 126

Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Procedure 5-1
Setting up SNMP
Perform this procedure to set up SNMP for the Horizon Compact system.
Required Action Steps
login Log in as a NOC account for SNMP v1 and v2c, or Super user for
SNMP v1, v2c and v3
set snmp access mode
[v1/v2c/v3/off]
Selects a SNMP access mode.
The default mode is SNMP mode v1.
Sequence:
set snmp access mode [v1/v2c/v3/off] press Enter
The system responds:
SNMP Mode: [v1 | v2c | v3 | off]
set snmp set request [on/off] Sets the SNMP access mode to on. This allows SNMP ‘set’ requests.
Sequence:
set snmp set request [on/off] press Enter
The system responds:
SNMP Set Requests are [on/off].
get snmp set request
Displays SNMP requests state. Displays if SNMP ‘set’ requests are
enabled.
The default state is off.
Sequence:
get snmp set requests press Enter
The system responds:
SNMP Set Requests are [on | off].