Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
set snmp trap host [host #]
[ipAddress] [enable/disable]
[communityString]
Adds an SNMP trap host to the list of receivers of SNMP traps. Specify
the IP address where the system sends traps.
Sequence:
set snmp trap host [host #] [ipAddress] [enable/disable]
[communityString] press Enter
The system responds:
Host# IpAddress Status CommunityString
1 0.0.0.0 disabled public
2 0.0.0.0 disabled public
3 3.3.3.3 enabled new text string here
4 0.0.0.0 disabled public
5 0.0.0.0 disabled public
Note: A maximum of 5 hosts are allowed. If all the hosts are filled in,
remove 1 host by overwriting the particular index.
To Next Page
Loading...